## Where is the voltage regulator installed?

The voltage regulator can be mounted inside or outside of the alternator housing. If the regulator is mounted outside (common on some Ford products) there will be a wiring harness connecting it to the alternator. The voltage regulator controls the field current applied to the spinning rotor inside the alternator.

## Are all voltage regulators the same?

All voltage regulators work about the same. They find a reference voltage between Volts In and Ground and or Volts Out that they use to set the output Voltage. This can make a standard 7805 give any voltage between 5 volts and your supply volts. This shows how much regulators are the same.

## Can 5 amps kill you?

Amperage, the higher the amps the more damage Some amperages and their effects on the body: 1 milliamp is the perceptual level; 5 milliamps is a shock felt; 6-30 milliamps is painful shock; 50-150 milliamps can result in extreme pain, respiratory arrest, severe muscular contraction; 1-5 amps results in ventricular …

## How much does 600 watts per hour cost?

Common Watts to Kilowatt-Hour Conversions

Power in Watts | Energy in Kilowatt-hours | Electricity Cost |
---|---|---|

500 W | 0.5 kWh | $0.060 per hr |

600 W | 0.6 kWh | $0.072 per hr |

700 W | 0.7 kWh | $0.084 per hr |

800 W | 0.8 kWh | $0.096 per hr |

## How many volts is a 20 amp circuit?

120-volt

## How many outlets can I run on a 20 amp breaker?

How many outlets can be put on a 20 amp circuit safely? A rule of thumb is to factor a maximum draw of 1.5 amps to each receptacle, which means you can put 10 outlets on a 20-amp circuit.

## How many duplex outlets can I put on a 20 amp circuit?

To find the maximum number of receptacles permitted on a 20-ampere breaker, divide the rating of the breaker by 1.5 amperes (20 รท 1.5 = 13.3 = 13). The maximum number of receptacles permitted on a 20-ampere, 120-volt breaker is 13 (see Figure 5).

## How many appliances can be on a 20 amp circuit?

One rule of thumb is to assign a maximum draw of 1.5 Amp to each receptacle, which will allow for 10 receptacle on a 20-amp circuit.

## How many outlets can you run off a GFCI?

There’s no limit. A standard GFCI will protect up to 20 amps, drawn from any combination of receptacles, either the built-in one or any number of additional ones connected to its load terminals.

## Is there a difference between GFI and GFCI?

There is no difference. Ground fault circuit interrupters (GFCI) and ground fault interrupters (GFI) are the exact same device under slightly different names. Though GFCI is more commonly used than GFI, the terms are interchangeable.