How do you reset the low tire pressure light on a Chevy Impala?

How do you reset the low tire pressure light on a Chevy Impala?

The Light Method

  1. Turn the ignition to the on position.
  2. Pull and push the headlight switch on and off three times. The tire pressure monitoring system is now reset and will recalibrate as you drive.

How do you reset the tire pressure sensor on a 2006 Chevy Impala?

2006-2010 Models

  1. Turn the ignition key to the “ON” position without starting the engine.
  2. Press the Remote Keyless Entry (RKE) transmitter’s LOCK and UNLOCK buttons simultaneously for five seconds.
  3. Activate the TPMS sensor.

Where is the TPMS reset button on a 2008 Chevy Impala?

Press and hold the “Check” icon beneath the “i” button. This is the reset button. After a second or two, this resets your TPMS system and rechecks the tire pressure.

How do you reset the tire pressure light on a 2007 Chevy Impala?

Turn the ignition off and then turn the car on and it will be reset. Push and hold the “check” icon beneath the “i” button. After a second or two, this resets your tpms system and will reset the tire pressure.

How do you reset the computer on a 2008 Chevy Impala?

Locate the erase button, and push it down. It can be found on Your scan tool. Once the codes have cleared from the computer, let the motor run for around 8 to 12 minutes. Check again, and the computer should be fully reset.

How do you know if you have a bad computer in your car?

Engine stalling or misfiring Another symptom of a bad or failing ECU is erratic engine behavior. A faulty computer may cause the vehicle to intermittently have issues such as stalling or misfires. The symptoms may come and go, and may not appear to have any sort of pattern to their frequency or severity.

How do you reset the computer on a Chevy Impala?

Remove the negative battery cable and set it aside, then turn the headlight switch to the ON position to drain the ECM of any residual power. Wait at least 10 minutes, and then turn it back off, re-hook up the negative battery cable, and go ahead and properly start Your Impala; the computer should be reset.

How do I disconnect my car battery?

Disconnecting A Car Battery

  1. Start By Turning The Ignition Off.
  2. Find Your Car Battery’s Negative Terminal.
  3. Loosen The Nut On The Negative Terminal With A Wrench.
  4. Remove The Negative Connector, Then Repeat With The Positive Terminal.
  5. Remove The Battery If Necessary.

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top