What is minimum tire tread depth that is safe?
What is bad tire tread depth?
Once your tire tread is below 1/8th of an inch of rubber, most industry experts suggest preparing to replace. If you’re down to 1/16th of an inch, your tires are considered worn out, and most states require immediate replacement.
Is 9/32 A good tire tread depth?
Tread depth is a vertical measurement between the top of the tread rubber to the bottom of the tire’s deepest grooves. In the United States, tread depth is measured in 32nds of an inch. If Lincoln’s entire head is visible, the tire is worn to approximately 2/32″ and is considered legally worn out in most States.
Is 5 32 A good tire tread depth?
6/32″ or higher: Your tire’s tread depth is sufficient. 5/32″: If snow-covered roads are a concern, you should consider replacing your tires. 4/32″: If you frequently drive on wet roads, consider replacing your tires. 3/32″: It’s time to start shopping for new tires.
When should you replace tire depth?
New tires typically come with 10/32” or 11/32” tread depths, and some truck, SUV and winter tires may have deeper tread depths than other models. The U.S. Department of Transportation recommends replacing tires when they reach 2/32”, and many states legally require tires to be replaced at this depth.
What percentage of tire tread is 6 32?
If the tread depth is 6/32″, it has 50 percent remaining. If the tread depth is 5/32″, it has 37.5 percent remaining. If the tread depth is 4/32″, it has 25 percent remaining. If the tread depth is 3/32″, it has 12.5 percent remaining.
What does 7 32 on a tire mean?
7/32 is partially worn. below 5/32 is seriously compromised for winter driving. below 4/32 is compromised for wet driving. 2/32 or less is worn out usually legal limit.
What is the minimum tread depth for front tires?
How many miles can you go on a 4 32 tread?
If you assume a linear rate of tread consumption (which is not necessarily a good assumption) then it takes ~3,500 miles to use up 1/32″ of tread, given your driving habits. Therefore you should get to 28,400 miles before your tires get down to 2/32″. This also implies that your tires had ~4/32″ depth 5,000 miles ago.
Is 4mm tire tread OK?
Fast facts: When to replace tires You must replace tires when the tread depth falls below 1.6 mm, which is the legal limit. Continental recommends changing summer tires at 3 mm and winter tires at 4 mm tread depth; after this point safety and performance characteristics are not optimal.
Is 4mm tread OK?
Any tyre that has a tread depth less than 1.6mm is illegal in the UK. A tyre with a tread depth of 4mm is a cause for concern as the tyre is 62% worn. At 3mm it is recommended that the tyre should be replaced.
How fast is tread?
Depending on the tread compound, the tread will wear down about 1/32 inch for every 5,000 to 8,500 miles of normal driving. Consequently, a new set of tires may last 40,000 to 70,000 miles on average. As the tread wears down, the depth of the grooves between the treads becomes shallower.
Do cheap tires wear faster?
They will put more wear on your car and cost you more money in gas and repairs in the long run. Tires with less drag have a sophisticated design and will typically cost a little more.
How many miles are left on my tires?
As a general rule, the original tires on a new vehicle or quality replacement tires should last up to 50,000 miles. However, many factors will have a significant impact on any tire’s life and may substantially shorten its life expectancy.
How many miles is a 500 treadwear rating?
This is a lower-middle level treadwear rating. Tires with a high-end rating of over 500 should deliver approximately 80,000 miles.
Is a 500 treadwear rating good?
The higher the tread wear number, the longer the tread wear will last. In this case, a higher number is better than a lower number. If the tire being tested gets a 500-tread wear rating, that means it’s expected to take five times as long to wear out as the control tire.
How long will a 200 treadwear tire last?