# What is the resistance of a wire if the length is doubled?

## What is the resistance of a wire if the length is doubled?

What happens to resistance when length is doubled? From the equation, we understand that resistance is directly proportional to the length of the conductor and inversely proportional to the crossectional area of the conductor. Doubling the length doubles the resistance.

## What happens to the resistance of a wire is its length decreases?

The resistance of a conductor is directly proportional to the length of the conductor and inversely proportional to the area of crossection f the wire. As the length of the wire decreases, the resistance of the wire also decreases.

## Which of the following does not change the resistance of a wire?

Answer on Question #45708, Physics, Electromagnetism The only item not listed here is voltage. Voltage value is not affect resistance (if we will not take into account any temperature changes).

## Which of the following will increase the resistance of a wire?

Increasing the resistivity of the material the wire is composed of will increase the resistance of the wire. Increasing the cross-sectional area of the wire will increase the resistance of the wire. Increasing the length of the wire will increase the resistance of the wire.

## What would reduce the resistance of a metal wire?

For parasitic resistance , it is available to reduce by shortening the length of metal wire , broadening the CSA(Cross-sectional area) of metal wire or lowering the large current flow path with a parallel layout method.

## Does a thick wire have more resistance than a thin wire?

The resistance of a thin wire is greater than the resistance of a thick wire because a thin wire has fewer electrons to carry the current. The relationship between resistance and the area of the cross section of a wire is inversely proportional.

## Does electricity move better through thick or thin wires?

The thin wire will conduct electricity, but there is more electrical resistance. The thicker wire is like the four lane highway. There’s a lot less electrical resistance, and as a result, that light bulb burns brighter because more electricity can reach it.

## Which has more resistivity a thick or thin wire of same material?

Resistivity depends on the nature of the substance and temperature. It does not depend on the dimensions, so resistivity of both is same. However the resistance of the thin wire will be more than that of the thick wire.

## How many ohms is an open circuit?

An open circuit implies that the two terminals are points are externally disconnected, which is equivalent to a resistance R=∞ . This means that zero current can flow between the two terminals, regardless of any voltage difference.

## What is the resistance of an open key explain?

Zero,when circuit is open, current is not flowing through it.So electrons are not flowing. When electrons are not flowing the conductor will not show resistance.

## How do you check for a short to ground with a multimeter?

Checking For A Short To Ground Set the rotary dial of the DVOM to the ohm position. Connect one lead of the meter to one end of the circuit to be tested. Connect the other lead of the meter to a good ground. If the DMM does NOT display infinite resistance (OL), there is a short to ground in the circuit.

## What is a high resistance reading?

Resistance is a measure of how much a device or material reduces the electric current flowing through it. Higher numbers indicate a higher resistance rating, which means more energy will be required to integrate the component in a circuit.

## How do you determine resistance?

To measure resistance:

1. Turn power to circuit OFF.
2. Turn digital multimeter dial to resistance, or ohms, which often shares a spot on the dial with one or more other test/measurement modes (continuity, capacitance or diode; see illustration below).
3. First insert the black test lead into the COM jack.
4. Then insert the red lead into the VΩ jack.

Begin typing your search term above and press enter to search. Press ESC to cancel.