Uncategorized

Where is the stator located?

Where is the stator located?

The stator is the coil of wire housed inside the engine case. A magnet on a shaft spins within the stator, creating alternating current (AC).

What is a stater on a Harley-Davidson?

The stator is an integral part of your Harley-Davidson Softail motorcycle’s charging system, generating an electrical field that is manipulated by a rotating magnetic flywheel to generate an alternating electrical current.

How do you clean a stator?

nicho627gb. Remove the foreign objects, spray it down with a light lube like WD 40 or if you must brake clean, and your done. So not use harsher chemicals or any mechanical means to clean it. If you damage the wiring or the lacquer coating on the wiring you will have ruined the stator.

How do you clean a stator cover?

Take the stator off and clean it seperately with contact cleaner. Clean the new stator case with kero or degreaser and a stiff brush. A parts washer is best if you can get access to one. Blow dry with compressed air.

How do you clean stator coils?

Re: Cleaning Stator Winding Remove stator and clean coil properly with smooth fine(soft) brush using Tina spirit or fuel in light application for quick dry than water. After cleaning or brushing off oil stains,deposits and or dirts,allow to dry up as it usually dry up fast(evaporation).

How do you clean stator magnets?

Steel wool will work, it will stick to the magnets and clean it up can be a pain. Fine grade sand paper 220 or so, blow the dust out where you’re done. Shine it all up and then put some dielectric grease on all of it.

Can a dirty stator cause no spark?

The stator coil generates the power for the spark plug and other accessories on small engines Without a stator there would be no spark at all, meaning the engine won’t run. While a stator is dying, it can produce a weak spark, causing the engine to miss or run poorly.

How do you clean a greasy stator?

If you want to clean oil you can use carburator cleaner or similar product like choke cleaner, it would take the oil out and any residual will evaporate or any contact cleaner will work too. Thats on the stator and the aluminum will clean both.

Can a rusty flywheel cause no spark?

Generally speaking, no. Rust on the flywheel won’t cause a no-spark problem. However, what caused the rust (excess moisture) could potentially soak into the windings of the stator and lead to a few wraps shorting out. Once that happens, then you could easily have a loss of spark.

How do you clean a flywheel?

How to Clean a Flywheel

  1. Wash your hands thoroughly with a mild soap before handling your vehicle’s flywheel.
  2. Spray a light, even coat of brake cleaner on the surface of the flywheel.
  3. Scrub the surface of the flywheel with the rough dish cleaning pad.
  4. Spray the surface of the flywheel with brake cleaner again.

Will rust on flywheel magnets will cause an ignition system to fail?

The most effective method to check for a good ignition system is to connect a spark tester to the high-tension lead, ground the tester and operate the starter. Rust on flywheel magnets will cause an ignition system to fail.

How do you tell if a flywheel magnets are getting bad?

Hold the screwdriver against the magnet, if the magnet pulls the screwdriver in, the magnet is fine. If it seems weak or does not pull the screwdriver in, the magnet needs to be replaced.

Can I use a rusty flywheel?

Re: Surface rust on flywheel Yeah it won’t really hurt anything. I run a wire wheel on a drill or angle grinder over them, cleans them up good enough.

Category: Uncategorized

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top